Modifications

Hangboard/fingerboard fait maison

12 octets ajoutés, 9 mars 2021 à 19:26
Update 5 : un pas en avant, deux pas en arrière
===Update 5 : un pas en avant, deux pas en arrière ===
(écrit le written on the 09/03/2021 et traduit le XXand translated on the 09/XX03/XXXX2021
With the manufacturer's info and photos I started 3D modeling on Fusion 360 (eurk, I know, but I'm familiar with it because my school trained me on it, but then I'll have to change my habits to blender but I don't have the courage to do it at the moment). I got a pretty bad result, let's say it's a failure (no photo will be published, I'm ashamed of it so much it is far from the expected result), the problem was that I could not reproduce precisely the curves of the model (if it was a decorative object or an object that I should not take in hand, no problem, but the whole point of a hangboard is based on the angles and the depth of its curves to be able to slide there one hand. So I looked to find a ready-made design. And there miraculously, I found two with one that even had brief printing instructions on the following website:
307
modifications